Go to the ‘Network > Interfaces’page and click on the ‘Configure’ icon next to interface X4. In the pop-up menu that appears, assign it to zone ‘trunkzone’and give it an IP address of ‘192.168.33.1’. Then, click on the ‘Advanced’ tab and set the X4 interfaceto be locked at 100Mbps full-duplex, since we previously set the switch’s trunk port for the same thing. When done, click on the ‘OK’ button to save and activate the changes.
See Figure 1 below for an example.
See Figure 1 below for an example.
On the ‘Network > Interface’ page,click on the ‘Add Interface…’ button. From the pop-up menu that
appears, assign the sub interface to zone ‘SALES’, enter the VLAN tag/ID as ‘50’, assign the parent
interface as ‘X4’, assign the sub interface an IP address of ‘192.168.50.1’, check the boxes next to ‘HTTPS’
and ‘Ping’ for management, then click on the ‘OK’ button to save an activate the changes.
See the below figure.
See the below figure.
On the ‘Network > Interface’ page, click on the ‘Add Interface…’ button. From the pop-up menu that
appears, assign the sub interface to zone ‘MARKETING’, enter the VLAN tag/ID as ‘75’, assign the parent interface as ‘X4’, assign the sub interface an IP address of ‘192.168.75.1’, check the boxes next to ‘HTTPS’ and ‘Ping’ for management, then click on the ‘OK’ button to save an activate the changes. See below for an example on the ‘Network > Interface’ page, click on the ‘Add Interface…’ button. From the pop-up menu that
appears, assign the sub interface to zone ‘ENG’, enter the VLAN tag/ID as ‘100’,assign the parent interface.
appears, assign the sub interface to zone ‘ENG’, enter the VLAN tag/ID as ‘100’,assign the parent interface.
As ‘X4’, assign the sub interface an IP address of ‘192.168.100.1’, check the boxes next to ‘HTTPS’ and
‘Ping’ for management, then click on the ‘OK’ button to save an activate the changes.
Go to the ‘Network > DHCP Server’ page. Make sure the checkbox next to ‘Enable DHCP Server’ is
Checked. Click on the ‘Add Dynamic’ button. From the pop-up that appears, choose ‘X4:V50’ from the
Dropdown next to ‘Interface’, make sure the box next to ‘Enable this DHCP Scope’ is checked, accept all
Defaults, and click on the ‘OK’ button to save and activate the scope.
Go to the ‘Network > DHCP Server’ page.Click on the ‘Add Dynamic’ button. From the pop-up that
Appears, choose ‘X4:V75’ from the drop-down next to ‘Interface’, make sure the box next to ‘Enable this
DHCP Scope’ is checked, accept all defaults, and click on the ‘OK’ button to save and activate the scope.
Watch This Video Also
No comments:
Post a Comment